There are three steps for golf club equipment


release time:

2018-06-19

When the ball head mold of golf club equipment is used for one or two layers of dipping, the ball head of golf club equipment will be soaked in three steps. First of all, the first step to use the gol

When the ball head mold of golf club equipment is used for one or two layers of dipping, the ball head of golf club equipment will be soaked in three steps.
First of all, the first step to use the golf club equipment to dip the ball head mold is to clean the wax mold. This is mainly to increase the roughness of the surface of the wax mold, so the surface of the ball head mold needs to be cleaned.
Next, the dip surface slurry of the ball head mould can be carried out through the golf club equipment. The surface slurry used here is a mixture of silica gel and zirconium powder, which is then evenly applied to the ball head mould through the golf club equipment.
Finally, let's talk about the third step, which is the problem of the slurry. In addition to the addition of zirconium oxide to the two-layer slurry, the other slurry is the addition of Malay powder or graphite powder.
There are three steps to dip the ball head of golf club equipment. After these three steps, the ball head mold dip of golf club equipment is completed.